Drilling op for lathe

26 Dec 2018 12:09 #122906 by mydani
Drilling op for lathe was created by mydani
Hello Ferm and users,

is there any possibility to use a cycle for drilling on a lathe? No luck with the boring operations as they do not like diameter to be zero (of course not).

Or only by adding custom g code?

29 Dec 2018 14:44 #123078 by andypugh
Replied by andypugh on topic Drilling op for lathe
i think you can use G83 etc.
31 Dec 2018 20:37 #123239 by FernV
Replied by FernV on topic Drilling op for lathe
Hi Daniel

Andy is right.
It is easy to write custom code to do this

Time to create page: 0.073 seconds
Powered by Kunena Forum