Daughterboard inputs not recognized in HALMETER
02 Nov 2017 18:06 #101201
by andypugh
Replied by andypugh on topic Daughterboard inputs not recognized in HALMETER
It should just need something like:
For each axis.
(motion pins are listed here: linuxcnc.org/docs/2.7/html/man/man9/motion.9.html )
net home-X-raw hm2_5i25.0.7i76.0.gpio-00-in debounce.0.0.in
net home-X-filt debounce.0.0.out axis.0.pos-lim-sw-in axis.0.neg-lim-sw-in axis.0.home-sw-inFor each axis.
(motion pins are listed here: linuxcnc.org/docs/2.7/html/man/man9/motion.9.html )
Please Log in or Create an account to join the conversation.
02 Nov 2017 19:25 #101203
by Dubmfg
Replied by Dubmfg on topic Daughterboard inputs not recognized in HALMETER
Woohoo! Plugged in the logic from my Linuxcnc .HAL and edited a bit of the postgui and now Its all working! Will post what worked for future people (likely me) to use as a reference for this combination.
Please Log in or Create an account to join the conversation.
02 Nov 2017 22:16 #101209
by Dubmfg
Replied by Dubmfg on topic Daughterboard inputs not recognized in HALMETER
Attached is my funtioning HAL, POSTGUI, and INI
Please Log in or Create an account to join the conversation.
Moderators: cncbasher
Time to create page: 0.066 seconds