PP din socket for tool setter

PP din socket for tool setter connections

I have a tool setter non Tormach but looks the same mine does not have a led only to switches one for the tool trip and the other NC for the over travel fault.

I am looking for the connections to this DIN socket for the two switches. I believe pin 1 is 5v dc - pin 4 is common - pin 2 not used - pin5 input - pin 3 is 12v dc

Check out Tormachs site for thier probes.
here's the direct link to the page and doc
tormach.com/passive-probe-kit-32309.html
pdf here
tormach.com/media/asset/t/d/td10088_pass...be_install_0515a.pdf

last page has the pin-out

this is my opinion
grab the Tormach doc on anything you're trying to implement. they do a decent job of documenting things

PIN1 = 12V
PIN2 = 5V
PIN4 = GND
PIN5 = Probe Input

belli wrote: PIN1 = 12V
PIN2 = 5V
PIN4 = GND
PIN5 = Probe Input

Yes that is looking at the back

double post

smgvbest wrote: Check out Tormachs site for thier probes.
here's the direct link to the page and doc
tormach.com/passive-probe-kit-32309.html
pdf here
tormach.com/media/asset/t/d/td10088_pass...be_install_0515a.pdf

last page has the pin-out

this is my opinion
grab the Tormach doc on anything you're trying to implement. they do a decent job of documenting things

Thanks. I had not seen that PDF

but I had the pin outs from the manual. But the tool setter I have has another switch lower down NC contacts I would like to put this switch in the estop chain or some other way of stopping the machine if the first one fails

any suggestions?