Tormach Released Control Baoard Schematics and Firmware Still Waiting VFD Files!

Thanks for pointing that out.

Don't look like we will be getting configuration files for the VFD, No Firmware for the Power Drawbar and  No other config bits for the pic chip's they asked for help recovering them I agreed to help and silence.

 

I think we have enough information from the schematics and firmware to reverse engineer quite a bit.  I have a PIC 16F1947 and development board to test out the firmware and monitor the inputs/outputs with a logic analyzer. 

To Contract_Pilot : You're Welcome.

Contract_Pilot, does your hex file match up to the one posted on Github for the Lathe Control Board?
Can you post your raw version.

Thanks,

Iron-Man

I finally have my hex file running.

Iron-Man

Contract_Pilot

Can you provide the approximate dimensions of the Lathe Board ?
Do you know if it is a 2 layer or 4 layer board?

Thanks,

Iron-Man

Sorry for the late reply was busy and then recently down with C19 for a couple weeks.

It should match up I updated it with the file in the repo. I saved the old file have to remember what thumb drive I put it on. 

Board size 5" X 6" Looks to be a 2 layer board.



I Notified Tormach CEO of the schematic discrepancy.