Has PNCCONF and STEPCONF ever been used in PathPilot?

Start
Prev
1
Next
End

Whitebarn
Offline
New Member

27 Jun 2023 15:44 #274309 by Whitebarn

Has PNCCONF and STEPCONF ever been used in PathPilot? was created by Whitebarn

Can PNCCONF and STEPCONF be used in PathPilot? Is it hidden somewhere in Tormach's software?

I have a Controller and Mesa card from Tormach. I'm using it on NonTormach Mill and Non-Tormach lathe.

Please Log in or Create an account to join the conversation.

Whitebarn
Offline
New Member

27 Jun 2023 15:52 - 27 Jun 2023 15:54 #274312 by Whitebarn

Replied by Whitebarn on topic Has PNCCONF and STEPCONF ever been used in PathPilot?

I'd like a more straightforward way of setting up pins, step and direction, spindle, etc.

I'm experienced in settings in Mach3 and Masso.

I've found file folders in PathPilot, and poked around. I am able to do a little Configuring.

Last edit: 27 Jun 2023 15:54 by Whitebarn. Reason: Simplifie my replie

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.059 seconds