Dot Peen Marking
15 Aug 2023 15:46 #278048
by Hendrixx
Dot Peen Marking was created by Hendrixx
I searched for a way to impliment dot peen marking for engraving part numbers on my plasma table, I understand that the tool paths are done on the cam side but is there a way to control the start and stop of the tip, I have the engraver on a pneumatic linear actuator using a 5/2 valve for the scribe arm up and down of the engraver and a separate valve for the scribe on
Please Log in or Create an account to join the conversation.
- snowgoer540
-
- Offline
- Moderator
-
Less
More
- Posts: 2388
- Thank you received: 779
15 Aug 2023 17:08 #278054
by snowgoer540
Replied by snowgoer540 on topic Dot Peen Marking
Have you had a look here:
linuxcnc.org/docs/devel/html/plasma/qtpl...c.html#plasma:scribe
If that doesn’t completely help, please let us know what questions you still have.
linuxcnc.org/docs/devel/html/plasma/qtpl...c.html#plasma:scribe
If that doesn’t completely help, please let us know what questions you still have.
Please Log in or Create an account to join the conversation.
Moderators: snowgoer540
Time to create page: 0.140 seconds