probe basic not working LinuxCNC V2.10.0
20 Sep 2023 09:58 #281212
by aabtech
probe basic not working LinuxCNC V2.10.0 was created by aabtech
hi, installing probe basic on Debian 12 LinuxCNC version 2.9 sim works fine, but when you upgrade to LinuxCNC V2.10.0 it not working. in Linuxcnc configuration selector probe basic lathe is working in sim. but probe basic not working and gives an error message.
Attachments:
Please Log in or Create an account to join the conversation.
20 Sep 2023 11:37 #281218
by Aciera
Replied by Aciera on topic probe basic not working LinuxCNC V2.10.0
twopass: Error in file ./hallib/core_sim_5.hal:
Pin 'iocontrol.0.lube' does not exist
'iocontrol.0.lube' has recently been removed from master so maybe try removing it from ' ./hallib/core_sim_5.hal' and try again.
Pin 'iocontrol.0.lube' does not exist
'iocontrol.0.lube' has recently been removed from master so maybe try removing it from ' ./hallib/core_sim_5.hal' and try again.
Please Log in or Create an account to join the conversation.
20 Sep 2023 20:36 - 20 Sep 2023 21:19 #281253
by aabtech
Replied by aabtech on topic probe basic not working LinuxCNC V2.10.0
Now it is working thanks very much
Attachments:
Last edit: 20 Sep 2023 21:19 by aabtech.
Please Log in or Create an account to join the conversation.
Time to create page: 0.064 seconds