Add qtdragon to New User Introduction Docs.

27 May 2023 23:51 #272297 by rodw

Add qtdragon to New User Introduction Docs. was created by rodw

Chris, how about taking a place at the table here?
linuxcnc.org/docs/2.9/html/user/user-int...rtual_control_panels
Eg. include an example of qtdragon here,

Please Log in or Create an account to join the conversation.

28 May 2023 00:45 #272298 by tommylight

Replied by tommylight on topic Add qtdragon to New User Introduction Docs.

Link is to control interfaces, VCP and GladeVCP, not to GUI's !

I would guess at QtDragon being a GUI...

Please Log in or Create an account to join the conversation.

28 May 2023 00:57 #272299 by rodw

Replied by rodw on topic Add qtdragon to New User Introduction Docs.

Well maybe it belongs one heading up.
linuxcnc.org/docs/2.9/html/user/user-int...ical-user-interfaces

But QTVCP is not covered in this doc either. It's a clearly a VCP

Please Log in or Create an account to join the conversation.

28 May 2023 01:43 #272303 by cmorley

Replied by cmorley on topic Add qtdragon to New User Introduction Docs.

yes I never noticed that section before.

The following user(s) said Thank You: rodw

Please Log in or Create an account to join the conversation.

Moderators: cmorley

Time to create page: 0.140 seconds