Captive nut, made on an EMCO 120P

More
04 Mar 2016 04:21 #71011 by tome
Captive nut, made on an EMCO 120P was created by tome
This may be a right of passage. Or perhaps just a fun waste of time :laugh: . Made this captive nut on the EmcoTurn 120P today:
It came out better than I expected. In fact, it took me a couple minutes under a microscope to find the "trick", and I knew generally where it was!








Attachments:

Please Log in or Create an account to join the conversation.

More
04 Mar 2016 11:41 #71018 by cncbasher
Replied by cncbasher on topic Captive nut, made on an EMCO 120P
nicely done !

Please Log in or Create an account to join the conversation.

More
05 Mar 2016 04:20 #71077 by cmorley
Replied by cmorley on topic Captive nut, made on an EMCO 120P
What no pic of it undone?

Please Log in or Create an account to join the conversation.

More
05 Mar 2016 15:30 - 05 Mar 2016 15:44 #71087 by tome
Replied by tome on topic Captive nut, made on an EMCO 120P

What no pic of it undone?



Did Houdini reveal his tricks? Did David Copperfield give his audience a picture if his methods? I think not. :-)
....

On the other hand, I am no magician









And here is a video of it being opened:
Attachments:
Last edit: 05 Mar 2016 15:44 by tome.
The following user(s) said Thank You: Fastest1

Please Log in or Create an account to join the conversation.

Time to create page: 0.150 seconds
Powered by Kunena Forum