Forum Menu

Engraver/Router Retrofit

More
7 years 3 months ago #139694 by Mike_Eitel
Replied by Mike_Eitel on topic Engraver/Router Retrofit
Fast and easy
And if you be careful it keeps the rounded "ball-hole" and does not harm the laker.

Please Log in or Create an account to join the conversation.

More
7 years 3 months ago #139696 by andypugh
Replied by andypugh on topic Engraver/Router Retrofit
This is getting increasingly off-topic, but I did hear a suggestion of using a hypodermic needle as the nozzle, specifically so that the tip can also be used to cut the wire by pushing against the board.

Please Log in or Create an account to join the conversation.

Time to create page: 0.108 seconds
Powered by Kunena Forum