HURCO KMB-1 Control Update

./Hurco_7i92.hal:347: Pin 'encoder.position' does not exist

It's almost certainly encoder.0.position that you need (or some other number that identifies the spindle encoder.

Thanks Andy, I'll go hunting for that missing connection and report back.

Not a missing connection, Andy pointed to a missing 0 :
error shows it should be

Apologies for Clumsy writing on my part,
I understand the issue and thanks for the clarification Tommy.

No worries, and you are welcomed, always.

My thought of testing the system with an Orient command, I understand now was very naïve.
From others examples, introducing this ability requires pretty much a total tear up of the whole spindle control setup, and a need to get into the ladder world not just a reroute of the enable signal, and that's a move way too far way from any comfort zone for me.
Ducking this piece of implementation brings me much relief.

Thanks for your effort to help.