×
Forum Header
Remote Extrernal Start Switch
- sjcdcheu
- Offline
- New Member
Less
More
- Posts: 7
- Thank you received: 0
22 Feb 2010 17:19 #1994
by sjcdcheu
Remote Extrernal Start Switch was created by sjcdcheu
I am new to the EMC2 and would like to set up a external start switch and link to the ParPort Pin 13 as input. Please tell me how to config and any script require?
Thank & My Best Regards,
Dason
Thank & My Best Regards,
Dason
Please Log in or Create an account to join the conversation.
- acemi
- Offline
- Junior Member
Less
More
- Posts: 31
- Thank you received: 0
22 Feb 2010 21:42 #2000
by acemi
Replied by acemi on topic Re:Remote Extrernal Start Switch
Please Log in or Create an account to join the conversation.
- sjcdcheu
- Offline
- New Member
Less
More
- Posts: 7
- Thank you received: 0
23 Feb 2010 00:42 #2009
by sjcdcheu
Replied by sjcdcheu on topic Re:Remote Extrernal Start Switch
Thank! Acemi, per my understanding and I need to add the net lines to hal file.
Code:
net program-run <= parport.1.pin-13-in
net program-run => halui.program.run
I will try later when the CNC ready.
My Best Regards,
Dason
Code:
net program-run <= parport.1.pin-13-in
net program-run => halui.program.run
I will try later when the CNC ready.
My Best Regards,
Dason
Please Log in or Create an account to join the conversation.
Time to create page: 0.051 seconds