Mach 3 conversion to Stepconf Wizard

Quick update for anyone else moving to LinuxCNC...

In Mach3 pin 15 is the Emergency stop, didn't convert as there appears to be no name for that pin in the Mach3 file... can be added during StepConf.
<Input25Active>1</Input25Active>
<Input25Port>1</Input25Port>
<Input25Pin>15</Input25Pin>
<Input25Neg>1</Input25Neg>
<Input25Emulated>0</Input25Emulated>
<Input25EmuKey>0</Input25EmuKey>

Output pin 17 is used for Charge Pump (12.5 kHz pulse) from PC so motors can only activate when Mach3 is Active. I tried setting that pin in StepConf but the axis tests didn't do anything - rejumpered the controller card (www.cncdoctor.co.uk/opto-bb-v1_61.html) to ignore that pin and they worked OK. Will get back to that at some stage - for now the ESTOP is good enough... don't expect a Linux box to randomly reboot :)

The "steps to linear movement" multiplies are off in StepConf so little movement in axis tests until parameters are increased - need to do a bit more work to figure out what they should be or if they are in the Mach3 file (the mil and machine are new to me so may have to make a test piece in Mach3 and measure it to ensure that Mach3 is actually correct)

Hello John,
Can I ask you to convert my settings also?
Sory for my double post, here is the file


Thank you.

Ooops, sorry about that....

here it is zipped

Hello BigJohnT
Would you mind convert my mach3 XML file too, please ?
will use it for a Shapeoko2 and need a xyyz (xyz-y)config

Thanks a lot,
best regards,
cle

[edit] originally attached the XML in a RAR, don't know why it got lost (:
sorry for the inconvenience (:

Hello all,

I've been playing around with an old CharlyRobot with obsolete controllers and drivers. I replace them with Leadshine MX3660 and LinuxCNC but there something wrong with the stepconf I tuned from the datasheet and manuals. Fortunately it comes with a Mach3 xml configuration file, and as I can see I found the right spot to get some help.

Here is the attachement, thanks in advance !
David

I, too, need a conversion from Mach 3 to LinuxCNC. Thank you in advance!

Thanks for all of the support you have given us neophytes for so long. I am taking the acquisition of a newer computer to make the switch to LinuxCNC. Right off the bat, Stepconf wants timing information for my Chinese motor controllers that I don't have. Hopefully that info is buried in this XML file.

Larry