×
Forum Header
Step Config setup questions?
21 Mar 2017 12:23 #89995
by andypugh
Not for step generation, ever.
Possibly for GPIO, but there is no driver.
Replied by andypugh on topic Step Config setup questions?
I'm curious to know if these usb gadgets work with linuxcnc.
Not for step generation, ever.
Possibly for GPIO, but there is no driver.
Please Log in or Create an account to join the conversation.
21 Mar 2017 21:46 #90033
by nicokid
Replied by nicokid on topic Step Config setup questions?
What a pity, parallel ports are becoming less common.
Please Log in or Create an account to join the conversation.
21 Mar 2017 21:50 #90034
by andypugh
I am not sure that they are.
But there are many other interfaces supported by LinuxCNC.
PCI works especially well.
Replied by andypugh on topic Step Config setup questions?
What a pity, parallel ports are becoming less common.
I am not sure that they are.
But there are many other interfaces supported by LinuxCNC.
PCI works especially well.
Please Log in or Create an account to join the conversation.
Time to create page: 0.151 seconds