×
Forum Header
NC Studio
- VMirv
-
Topic Author
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
10 Sep 2022 13:55 #251615
by VMirv
NC Studio was created by VMirv
Hello folk,
I am trying to install Linux cnc
With NC studio controller , is that possible
or I am wasting my time?
Nc studio has dedicated hardware
like a PCI card and a controller
thanks to everyone who will help me
Albert
I am trying to install Linux cnc
With NC studio controller , is that possible
or I am wasting my time?
Nc studio has dedicated hardware
like a PCI card and a controller
thanks to everyone who will help me
Albert
Please Log in or Create an account to join the conversation.
- MX_Master
-
- Offline
- Premium Member
-
Less
More
- Posts: 92
- Thank you received: 46
10 Sep 2022 16:34 #251620
by MX_Master
Replied by MX_Master on topic NC Studio
You must write a HAL driver for the LinuxCNC to use NCStudio PCI card.
Please Log in or Create an account to join the conversation.
- VMirv
-
Topic Author
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
10 Sep 2022 21:38 #251652
by VMirv
Replied by VMirv on topic NC Studio
I see seems difficult to compile a Hardware abstraction layer.
Thanks, but before make something like this I will check something of pre-compiled.
Thanks, but before make something like this I will check something of pre-compiled.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23262
- Thank you received: 4924
17 Sep 2022 19:17 #252198
by andypugh
Replied by andypugh on topic NC Studio
It sounds like NCStudio includes a controller. LinuxCNC is a controller. You can't use two controllers.
Please Log in or Create an account to join the conversation.
Time to create page: 0.098 seconds