- Configuring LinuxCNC
- Configuration Tools
- StepConf Wizard
- Re:Configuring Spindle Feedback with Proximity Sensor
×
Forum Header
Re:Configuring Spindle Feedback with Proximity Sensor
28 Mar 2011 20:28 #8220
by RotarySMP
Re:Configuring Spindle Feedback with Proximity Sensor was created by RotarySMP
Thanks for the quick replies Rus and John. It is getting late here, so I'll read the Basic Hal instruction before I turn in.
John that other thread link is this thread. Is there another good one out there? I searched for "spindle pulse" and the forum returns four pages of hits, but pages 2 through 4 come up empty when I click on them.
John that other thread link is this thread. Is there another good one out there? I searched for "spindle pulse" and the forum returns four pages of hits, but pages 2 through 4 come up empty when I click on them.
Please Log in or Create an account to join the conversation.
28 Mar 2011 20:33 #8221
by BigJohnT
Replied by BigJohnT on topic Re:Configuring Spindle Feedback with Proximity Sensor
Unfortunately the search is a little broken. You can use a google site search like this
spindle threading site:www.linuxcnc.org
I didn't realize I was linking to this thread.
John
spindle threading site:www.linuxcnc.org
I didn't realize I was linking to this thread.
John
Please Log in or Create an account to join the conversation.
- Configuring LinuxCNC
- Configuration Tools
- StepConf Wizard
- Re:Configuring Spindle Feedback with Proximity Sensor
Time to create page: 0.085 seconds