Remora - ethernet

Is Remora working on a BTT Octopus over ethernet? I don't have SPI available on the host, trying to find out what the max uart speed on the host PC is but from what I gather Remora only runs debug over uart. I've got extra ethernet ports so I can go that way assuming the Octopus does actual ethernet over the RJ45 and not just CAN

Hmmm i think Octopus does not have RJ45, it has RJ11.
I got disapointed by it, sorry to have to forward that to you.

A bit fuzzy on this, it has been on 24/7 for over 4 months behind a 3D printer.

Lol maybe you're right, I didn't even look at it that good. I was planning on using Marlin over uart with a project but Marlin sucks.

So the only thing Remora can actually do with an Octopus is SPI then?

I should have paid a little more attention to the comments at the beginning of this thread. I didn't realize what the "w5500" was. Has anyone gotten Remora working over ethernet with the w5500 on an Octopus?

I dont think theres a problem with it working, Scott just tells me its not ready for the big time yet, he needs to work on some DMA stuff to make it better.

I should have that w5500 board today. I have Marlin sort of running on the Octopus I put in the PnP machine I just built but I'm not a fan of Marlin so I want to try running LinuxCNC through linuxcncrsh. That's a whole nother battle but if I can get Remora running on it with just a basic Axis config I'll probably stick with it and figure the rest out later.