Steppers work in Stepconf Wizard, but not in EMC2
25 May 2011 11:26 - 25 May 2011 11:29 #10057
by cncbasher
Replied by cncbasher on topic Re:Steppers work in Stepconf Wizard, but not in EMC2
For Anyone else struggling setting up a Zenbot controller
it requires pin 1 setting as Amplifier Enable
and by default is set for 16x microstepping
Dave
it requires pin 1 setting as Amplifier Enable
and by default is set for 16x microstepping
Dave
Last edit: 25 May 2011 11:29 by cncbasher.
Please Log in or Create an account to join the conversation.
- TwoFeetDown
-
- Offline
- New Member
-
Less
More
- Posts: 18
- Thank you received: 8
23 Mar 2015 05:01 #57095
by TwoFeetDown
Replied by TwoFeetDown on topic Re:Steppers work in Stepconf Wizard, but not in EMC2
A great big THANK YOU to the posters on this thread. I've been tearing my hair out trying to get my motors to respond in LinuxCNC and the comments about inverting the amp-enable signal steered me in the right direction.
I'm beginning to think I may actually get this thing running someday!
I'm beginning to think I may actually get this thing running someday!
Please Log in or Create an account to join the conversation.
Time to create page: 0.122 seconds