Parting Off

08 Aug 2012 19:01 #22979 by VNR
Replied by VNR on topic Re:Parting Off

Now that I think about it that question doesn't make any sense as to part of you need to be in center to get a full cut off.

The tool must be below the center line because there is vibration (chatter).
When vibration occurs, if the tool is upper the center line, it tends to lock (clamp) over the piece breaking itself; if the tool is below the center line, it tends to unlock.

Please Log in or Create an account to join the conversation.

Moderators: piasdom
Time to create page: 0.062 seconds
Powered by Kunena Forum