Mesa in Australia?

Spectre wrote: I have a file that works on Mach3 but when I load it into LCNC it comes up with a missing tool number error.

I guess this means that there are tools in the Mach3 tool-table, or the Fusion tool-table that have not been put in the LinuxCNC tool-table.

DOH !!! of course I am not thinking correctly. I found the tool table in LCNC last night and saw there was hardly anything there. So that will be the reason. Another question the stepconv wizard I would have though pulled all the info from the XML file but it doesnt. Even the steps per unit doesnt come across when you convert you have to manually put a lot of extra stuff in there

Hi John,

Just tried to purchase a Mesa 5i25 card from your website and no shipping options to Australia were available. Your contact link on the website is dead too.

Cheers,
Jason.

Just be aware that the US Postal Service has been doing some screwy things in October with the suspension of shipments to AU and NZ plus some other countries.  I do not know if this has been resumed but if it is still in place it could pose some problems for shipping if you are trying to avoid being reamed by the typical courier pirates.

I think the postal services all around the world are having massive problems. Often Australia Post will quote a customer a rate on my online store but when I go to ship it, they say there is no route to the destinations.

I would touch base with Andrew in New Zealand  carbidecutters.co.nz/ or deal direct with Mesa but pay the extra for Fedex shipping which have been pretty good through this. Don't ever use USPS or UPS based on my experience.

I cant talk to UPS but in fairness to USPS my small sample set from John has been 100% successful.  But clearly Rod has not been as fortunate.