Need Help for mesa 7i76e setup with linuxcnc
23 Feb 2019 19:43 #127016
by PCW
Replied by PCW on topic Need Help for mesa 7i76e setup with linuxcnc
Not really, the analog output is fully isolated from ground so if you measure ~10V from TB4.3 to TB4.1 and 7V from TB4.2 to TB4.1 and LinuxCNC has requested full scale output (spinout=maxscale=maxlimit), This is a hardware fault of some kind
The following user(s) said Thank You: yrsiddhapura
Please Log in or Create an account to join the conversation.
- yrsiddhapura
- Offline
- Premium Member
-
Less
More
- Posts: 131
- Thank you received: 5
24 Feb 2019 09:56 #127042
by yrsiddhapura
Replied by yrsiddhapura on topic Need Help for mesa 7i76e setup with linuxcnc
Dear PCW
i can manage with 7.5V and m also have a 3phase spindle encoder(A,B,I, 1024ppr) connected with 7i76e is it possible to synchronize with 7.5v instead of 10V and i can set 7.5v as max input.
i can manage with 7.5V and m also have a 3phase spindle encoder(A,B,I, 1024ppr) connected with 7i76e is it possible to synchronize with 7.5v instead of 10V and i can set 7.5v as max input.
Please Log in or Create an account to join the conversation.
Time to create page: 0.067 seconds