Need help with 7i96 card that stoped working.
- oficinerobotica
-
Topic Author
- Offline
- Senior Member
-
Less
More
- Posts: 47
- Thank you received: 12
29 Jul 2021 15:45 #216234
by oficinerobotica
Replied by oficinerobotica on topic Need help with 7i96 card that stoped working.
Yes, the red init led is on only when linuxcnc is closed.
What would be your suggestion going foreword given the info at hand?
Is the power chip a common smd that could be changed by someone with enough knowledge or is it a specialised component?
Bare in mind that I'm in Europe. I don't know how mesa operates here.
What would be your suggestion going foreword given the info at hand?
Is the power chip a common smd that could be changed by someone with enough knowledge or is it a specialised component?
Bare in mind that I'm in Europe. I don't know how mesa operates here.
Please Log in or Create an account to join the conversation.
- PCW
-
- Offline
- Moderator
-
Less
More
- Posts: 18541
- Thank you received: 5089
29 Jul 2021 17:12 #216240
by PCW
Replied by PCW on topic Need help with 7i96 card that stoped working.
The driver chips for STEP/DIR 0..3 are a 74ACT540 and a 74ACT541 (TSSOP package). The driver chip for STEP/DIR 4 is a 74ACT04. All of these are inexpensive
and commonly available.
If there has been a 5V overvoltage, the ACT parts are the first to go...
and commonly available.
If there has been a 5V overvoltage, the ACT parts are the first to go...
The following user(s) said Thank You: oficinerobotica
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.108 seconds