extra axis on 7i96 with bob

Did you add the "--addr 10.10.10.10"
 

yes I ran your exact command

Strange, does:

mesaflash --device ethernet --addr 10.10.10.10 --write 7i96_5abob_d.bit --reload

work?


 

"no ethernet board found",

I must admit I am not super linux savy, could i be doing something wrong related to either the boards' jumper or some other config related issue?

Can you ping the card?

How are jumpers W5 and W6 on the 7I96 set

What does:

ip a

report?
 


 

card pings no problem,

ip a reports :

ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
link/ether 00:23:24:b5:80:2a brd ff:ff:ff:ff:ff:ff
inet 10.10.10.8/24 brd 10.10.10.255 scope global noprefixroute eno1
valid_lft forever preferred_lft forever
3: wlp1s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
link/ether 22:6b:6c:9f:f3:51 brd ff:ff:ff:ff:ff:ff


w5 and W6 are set as such :