Hydraulic Tube Bender - Manual to CNC Conversion
- JimPanski
- Offline
- Senior Member
-
Less
More
- Posts: 60
- Thank you received: 3
29 Jul 2019 06:37 #140863
by JimPanski
Replied by JimPanski on topic Hydraulic Tube Bender - Manual to CNC Conversion
Hi andy,
no, sadly there are only 2 port valves in the machine.
no, sadly there are only 2 port valves in the machine.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23297
- Thank you received: 4938
29 Jul 2019 08:53 #140868
by andypugh
You would still use PID, but either connect the output of the PID to a wcomp component and use the wcomp.over and wcomp.under outputs to drive the valve, or possibly use a very low frequency PWM. Do you find yourself doing “manual pwm” when operating the machine?
Replied by andypugh on topic Hydraulic Tube Bender - Manual to CNC Conversion
no, sadly there are only 2 port valves in the machine.
You would still use PID, but either connect the output of the PID to a wcomp component and use the wcomp.over and wcomp.under outputs to drive the valve, or possibly use a very low frequency PWM. Do you find yourself doing “manual pwm” when operating the machine?
Please Log in or Create an account to join the conversation.
Time to create page: 0.082 seconds