Fusion 360 Win 10 EOL

Used to do that on a weekly basis when I was installing playground equipment, the supplier would ship all the stuff up not powder coated and we'd spend time packing it all and shipping it off to the powder coaters then doing all the nutserts. Man there was a lot of double handling.

Cant do this anymore bye all wrote:

Used to do that on a weekly basis when I was installing playground equipment, the supplier would ship all the stuff up not powder coated and we'd spend time packing it all and shipping it off to the powder coaters then doing all the nutserts. Man there was a lot of double handling.

That sounds familiar. I add a  fold in there too. Then package into a kit and label the bag. They look alright when done. This one was fully outsourced and they painted after nutserting but they look so much nicer if the nutsert goes in later. 

 

 

FWIW my work on the adaptive toolpaths got merged in FreeCAD- it's in the weekly builds. See: forum.freecad.org/viewtopic.php?t=96548

tl;dr is it adds a more-or-less one-click "rough the entire model" mode and- perhaps more relevantly- properly evaluates the stock and model instead of blindly projecting the contour you specify. Put differently, it's far smarter about not machining into the model, including avoiding areas it can't reach in 2.5D due to overhanging geometry. The attached image shows that on a demo model I threw together.

Not world-changing, but still a really nice QoL upgrade if you like adaptive toolpaths. Plenty of other... quirks... in FreeCAD remain, of course, but it's getting better all the time if you're not afraid of the weekly builds.

That's a really nice improvement, can't wait until the next release to try it out.

So it's December 31st 2025 and I am curious if Fusion 360 will actually stop working on my Windows 10
machine at 12:00am January 1st 2026.  As I write this message it's 3:20 pm and currently Fusion 360 is
still operational.  I will keep it logged on to Linuxcnc and Fusion 360 and update on my findings.
With that said I am sure it is already January 1st somewhere in the world . Has any one tried seeing if
Fusion 360 still works for them on Win 10?

my1987toyota wrote:

With that said I am sure it is already January 1st somewhere in the world . Has any one tried seeing if
Fusion 360 still works for them on Win 10?

RodW and "unknown" are in Australia so they are already in 2026, and i think both used Fusion360 at some point in time, and they both monitor the "recent topic" section of this forum, so maybe they chime in, granted new years day so might, might be hangover ...