Jog wheel
- Mike_Eitel
-
Topic Author
- Offline
- Platinum Member
-
Less
More
- Posts: 1150
- Thank you received: 184
07 May 2010 18:26 #2820
by Mike_Eitel
Jog wheel was created by Mike_Eitel
I was asked if it is possible to have a real jog wheel connected
I have no glue how to do, just have a 3 motor (stepper ) via parport mil.
in my opinion it shoul be possible by two input pins?
THX
I have no glue how to do, just have a 3 motor (stepper ) via parport mil.
in my opinion it shoul be possible by two input pins?
THX
Please Log in or Create an account to join the conversation.
08 May 2010 10:26 #2821
by Rick G
Replied by Rick G on topic Re:Jog wheel
Take a look here wiki.linuxcnc.org/cgi-bin/emcinfo.pl?EmcKnowledgeBase
Go down to advanced configuration.
Rick G
Go down to advanced configuration.
Rick G
Please Log in or Create an account to join the conversation.
Time to create page: 0.100 seconds