1. LinuxCNC
  3. General LinuxCNC Questions
  5. Motors Jitter and even Reverse at low speed

Motors Jitter and even Reverse at low speed

More
05 Nov 2014 23:38 #52823 by fcanesin
Motors Jitter and even Reverse at low speed was created by fcanesin
Hello,

Sorry about ressurecting this old post but I have the same problem.

At low speed (1.5mm/s) I lose some steps and even reverse the direction.

Did you find a solution for your problem ?

Tks,

Fernando.

Please Log in or Create an account to join the conversation.

  1. LinuxCNC
  3. General LinuxCNC Questions
  5. Motors Jitter and even Reverse at low speed
Time to create page: 0.050 seconds
Powered by Kunena Forum