Request for links for harware
- patburden
- Offline
- New Member
-
Less
More
- Posts: 11
- Thank you received: 0
20 Jan 2015 21:53 #55205
by patburden
Request for links for harware was created by patburden
I have an old Robotool 3 axis mill, all the electronics in back have shot craps. I want to replace everything between my computer and the servo drives. they are 1/4 hp Leeson 65v dc. I plan to use EMC for my control.
I need help picking out a break out board, power supply, and servo drives, and any thing else I might need.
Does anybody have any recommendations?
Thank you
I need help picking out a break out board, power supply, and servo drives, and any thing else I might need.
Does anybody have any recommendations?
Thank you
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23320
- Thank you received: 4946
04 Feb 2015 19:58 #55684
by andypugh
What control protocol do the drives use? Are they analogue-voltage (+/- 10V) or something else?
(sorry for the very slow reply, I am sweeping-up unanswered posts)
Replied by andypugh on topic Request for links for harware
I have an old Robotool 3 axis mill, all the electronics in back have shot craps. I want to replace everything between my computer and the servo drives
What control protocol do the drives use? Are they analogue-voltage (+/- 10V) or something else?
(sorry for the very slow reply, I am sweeping-up unanswered posts)
Please Log in or Create an account to join the conversation.
Time to create page: 0.054 seconds