LinuxCNC Toolsetter config
12 Jan 2017 16:00 #85656
by timmert
Replied by timmert on topic LinuxCNC Toolsetter config
updated to the latest development release, but doesn't solve it
Please Log in or Create an account to join the conversation.
12 Jan 2017 18:54 - 12 Jan 2017 19:12 #85660
by timmert
Replied by timmert on topic LinuxCNC Toolsetter config
It couldn't be caused by noise? Like this thread: forum.linuxcnc.org/10-advanced-configura...h-touch-off?start=30
HAL Meter shows false and true (when pressed).
That's a bit strange though.
Edit
Found it!!! finally
Can't explain exactly why.
This is the working config in my .hal file
# ---probe signal---
net probe-in => motion.probe-input
net probe-in <= hm2_5i25.0.7i76.0.0.input-11-not
It should be done like this if I check the documentation.
But it didn't work: net probe-in => hm2_5i25.0.7i76.0.0.input-11-not
HAL Meter shows false and true (when pressed).
That's a bit strange though.
Edit
Found it!!! finally
Can't explain exactly why.
This is the working config in my .hal file
# ---probe signal---
net probe-in => motion.probe-input
net probe-in <= hm2_5i25.0.7i76.0.0.input-11-not
It should be done like this if I check the documentation.
But it didn't work: net probe-in => hm2_5i25.0.7i76.0.0.input-11-not
Last edit: 12 Jan 2017 19:12 by timmert.
Please Log in or Create an account to join the conversation.
Time to create page: 0.061 seconds