- General
- General LinuxCNC Questions
- ONE spindle motor+drive to use with Spindle And C-Axis (vel and pos mode)
ONE spindle motor+drive to use with Spindle And C-Axis (vel and pos mode)
29 Jun 2017 22:15 #95193
by rodw
Replied by rodw on topic ONE spindle motor+drive to use with Spindle And C-Axis (vel and pos mode)
forum.linuxcnc.org/plasma-laser/32585-scalethcad-component
Its one of a series of components I've written and documented for plasma in the plasma and laser section on the forum.
This one just makes it easy to use the Mesa THCAD board in LinuxCNC so should work in 2.5 but to go any further, you need to be using the dgarr/external_Offsets branch as it contains a PID based THC component
Its one of a series of components I've written and documented for plasma in the plasma and laser section on the forum.
This one just makes it easy to use the Mesa THCAD board in LinuxCNC so should work in 2.5 but to go any further, you need to be using the dgarr/external_Offsets branch as it contains a PID based THC component
Please Log in or Create an account to join the conversation.
04 Jul 2017 11:02 #95350
by andypugh
I believe this was just a sample section of HAL code to show that one input can drive several outputs very easily in HAL.
Replied by andypugh on topic ONE spindle motor+drive to use with Spindle And C-Axis (vel and pos mode)
please do one favor tell me how to use this thcad10 with linuxcnc version 2.5.3
I believe this was just a sample section of HAL code to show that one input can drive several outputs very easily in HAL.
The following user(s) said Thank You: snujcnc
Please Log in or Create an account to join the conversation.
- General
- General LinuxCNC Questions
- ONE spindle motor+drive to use with Spindle And C-Axis (vel and pos mode)
Time to create page: 0.396 seconds