Install PID module for LinuxCNC
- Todd Zuercher
-
- Offline
- Platinum Member
-
Less
More
- Posts: 4998
- Thank you received: 1459
16 Nov 2017 13:40 #101892
by Todd Zuercher
Replied by Todd Zuercher on topic Install PID module for LinuxCNC
Usually pid.N.enable is connected to the enable signal for the axis/joint it is used with (axis.N.amp-enable-out).
The following user(s) said Thank You: Bello
Please Log in or Create an account to join the conversation.
- Bello
-
Topic Author
- Offline
- Senior Member
-
Less
More
- Posts: 43
- Thank you received: 2
16 Nov 2017 13:44 #101894
by Bello
Replied by Bello on topic Install PID module for LinuxCNC
Ok, got it, this is the reason why my axis was not able to move.
Thank you!
Thank you!
Please Log in or Create an account to join the conversation.
Time to create page: 0.125 seconds