phoenix wrote: I'm not intended to offend any of u but I'm sick of getting same eror again and again its just say parport. 0.pin-8-out doesn't exists
I am sure that has been answered for you previously more than once.
Or plasmac voltage in needs to connected to float in pin and parport doesnt have float in pin
From the man page for plasmac:
Code:
plasmac.arc-voltage-in
float in arc voltage input [mode 0 & mode 1] see Notes above
The notes referred to:
Code:
NOTES
- arc-voltage-in is NOT an analog input, it is a floating point number
representing the arc voltage which should be linear. An example would
be the velocity output of an encoder. To set it up at zero volts, use
the actual value of arc-voltage-in as the value for arc-voltage-off‐
set, then apply a known voltage and set arc-voltage scale to known
voltage / arc-voltage-out.
