post processor
- Nate
- Offline
- Senior Member
-
Less
More
- Posts: 50
- Thank you received: 1
13 May 2020 20:46 #167679
by Nate
post processor was created by Nate
what post processor dose everyone use in sheetcam for linuxcnc i tried linuxcnc thc and i get a G-code error of Near line 7 of ......... must use g0 g1 with g53
Please Log in or Create an account to join the conversation.
- bbsr_5a
- Offline
- Platinum Member
-
Less
More
- Posts: 544
- Thank you received: 105
15 May 2020 08:27 #167817
by bbsr_5a
Replied by bbsr_5a on topic post processor
in general you shoud avoid G53 in Gcode
are you shure you did not select the Mach3 as this uses G53
i added my 2 posts
are you shure you did not select the Mach3 as this uses G53
i added my 2 posts
Please Log in or Create an account to join the conversation.
Time to create page: 0.056 seconds