AKZ250 lazyboy 77
- Jmh474
- Offline
- New Member
-
Less
More
- Posts: 8
- Thank you received: 0
17 Feb 2021 10:48 #199144
by Jmh474
AKZ250 lazyboy 77 was created by Jmh474
Good morning all first time poster.
I'm in the middle of building a diy cnc and I'm using a usb AKZ250 controller board and I was wondering if its possible to use linuxcnc with this board it supports mach3 I only paid £25 for the board, but it didn't come with any software.
Any advice would be greatly appreciated
Thanks
I'm in the middle of building a diy cnc and I'm using a usb AKZ250 controller board and I was wondering if its possible to use linuxcnc with this board it supports mach3 I only paid £25 for the board, but it didn't come with any software.
Any advice would be greatly appreciated
Thanks
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19488
- Thank you received: 6535
17 Feb 2021 10:56 #199145
by tommylight
Replied by tommylight on topic AKZ250 lazyboy 77
LinuxCNC can not work with USB motion controllers, to many reasons for that but mainly latency and timing reliability on USB is terrible.
But it does work with a parallel port, Mesa boards from www.mesanet.com, Pico boards, Ethercat, and some other stuff.
But it does work with a parallel port, Mesa boards from www.mesanet.com, Pico boards, Ethercat, and some other stuff.
Please Log in or Create an account to join the conversation.
Time to create page: 0.052 seconds