New here and my first build

First off just want to say hello to everyone and look forward to using this forum (a lot)

I'm in the middle of building my first ever cnc router, iv not got any cnc experience, but I'm learning loads.

It's only a simple build using nema 23 steppers and tb6600, once I get the router up and running I plan on replacing the drivers eventually.

so iv got a pokeys57cnc www.poscope.com/product/pokeys57cnc/ controller and was hoping that linuxcnc would work with it saving me to fork out for mach3 or 4. It can use usb or ethernet for communication.

thanksfor any help or advice any one can offer