1. LinuxCNC
  3. General LinuxCNC Questions
  5. Raspberry PI4, MESA 7I96S problems

Raspberry PI4, MESA 7I96S problems

  • tommylight
  • tommylight's Avatar
  • Away
  • Moderator
  • Moderator
More
13 Nov 2024 01:21 #314359 by tommylight
Replied by tommylight on topic Raspberry PI4, MESA 7I96S problems

I was always under the impression that up to version 3 the ethernet was on the USB bus and 4 and after were on the PCIe bus.

Me too ! :)

Please Log in or Create an account to join the conversation.

More
13 Nov 2024 02:15 #314361 by PCW
Replied by PCW on topic Raspberry PI4, MESA 7I96S problems
Yes I had forgotten, its the RPI3 that uses USB --> Ethernet
I should know since I have run a Mesa Ethernet card from a RPI4.

 (I think some RPI4 --> Ethernet motion card users needed to increase
the servo thread period to 2 ms to get it to run reliably)
The following user(s) said Thank You: tommylight

Please Log in or Create an account to join the conversation.

  1. LinuxCNC
  3. General LinuxCNC Questions
  5. Raspberry PI4, MESA 7I96S problems
Time to create page: 0.115 seconds
Powered by Kunena Forum