- LinuxCNC
- General LinuxCNC Questions
- using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE
using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE
- canagman
- Offline
- New Member
-
Less
More
- Posts: 1
- Thank you received: 0
21 Feb 2024 21:48 #293929
by canagman
using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE was created by canagman
Even with all wiring disconnected to that input.....Linux CNC with Hal meter says its on....
I haven't read anything definitive as an answer....
Ty for any suggestions
I haven't read anything definitive as an answer....
Ty for any suggestions
Please Log in or Create an account to join the conversation.
- PCW
-
- Offline
- Moderator
-
Less
More
- Posts: 17935
- Thank you received: 4809
22 Feb 2024 00:06 #293942
by PCW
Replied by PCW on topic using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE
A few more details would help...
What hardware are you using?
Unconnected inputs may be high,low,
or indeterminate, depending on the hardware.
What hardware are you using?
Unconnected inputs may be high,low,
or indeterminate, depending on the hardware.
Please Log in or Create an account to join the conversation.
- LinuxCNC
- General LinuxCNC Questions
- using a standard FPGA....and 2.8.4....an input pin is suddenly stuck TRUE
Time to create page: 0.257 seconds