- LinuxCNC
- General LinuxCNC Questions
- Touch Screen recognized in Settings | Mouse and Touchpad but touches do nothing
Touch Screen recognized in Settings | Mouse and Touchpad but touches do nothing
- slowpoke
- Offline
- Elite Member
-
Less
More
- Posts: 189
- Thank you received: 26
05 Dec 2024 17:43 #316031
by slowpoke
Touch Screen recognized in Settings | Mouse and Touchpad but touches do nothing was created by slowpoke
I'm trying out a new touchscreen with LinuxCNC 2.91 on RaspberryPi today.
The Touch Screen is recognized in Settings | Mouse and Touchpad; two instances of wch.cn TouchScreen, however touching the screen has no effect either on the desktop or from within Axis.
Do I need to enable a driver, or do something special to get this to work?
The keyboard, mouse etc are also recognized and they both seem to work just fine.
The Touch Screen is recognized in Settings | Mouse and Touchpad; two instances of wch.cn TouchScreen, however touching the screen has no effect either on the desktop or from within Axis.
Do I need to enable a driver, or do something special to get this to work?
The keyboard, mouse etc are also recognized and they both seem to work just fine.
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19631
- Thank you received: 6619
06 Dec 2024 02:28 #316067
by tommylight
Replied by tommylight on topic Touch Screen recognized in Settings | Mouse and Touchpad but touches do nothing
Might have better luck with this in the Debian forums, it is Linux related.
The following user(s) said Thank You: slowpoke
Please Log in or Create an account to join the conversation.
- LinuxCNC
- General LinuxCNC Questions
- Touch Screen recognized in Settings | Mouse and Touchpad but touches do nothing
Time to create page: 0.088 seconds