Activity Light
- chuckp47
- Offline
- New Member
-
Less
More
- Posts: 12
- Thank you received: 1
31 Mar 2025 13:31 #325399
by chuckp47
Activity Light was created by chuckp47
We would like our LinuxCNC system to control an activity light. This would be a red light on the machine active when the motors are engaged. Does LinuxCNC already have a feature to control such a thing? Where should I look to find the interface?
We are using a Mesa board and a Raspberry Pi. Can I route a control signal through to an output pin on the Mesa board?
Thank you.
We are using a Mesa board and a Raspberry Pi. Can I route a control signal through to an output pin on the Mesa board?
Thank you.
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 20169
- Thank you received: 6861
31 Mar 2025 14:09 #325403
by tommylight
Replied by tommylight on topic Activity Light
Usable hal pins
amplifier-enable
machine-is-on
e-stop-out
x-enable
something like this
x-enable hm2_7i76e.0.7i76.0.0.output-00
Replace board and pins accordingly.
amplifier-enable
machine-is-on
e-stop-out
x-enable
something like this
x-enable hm2_7i76e.0.7i76.0.0.output-00
Replace board and pins accordingly.
Please Log in or Create an account to join the conversation.
- Todd Zuercher
-
- Offline
- Platinum Member
-
Less
More
- Posts: 4987
- Thank you received: 1455
31 Mar 2025 17:05 #325414
by Todd Zuercher
Replied by Todd Zuercher on topic Activity Light
Maybe the hal pin "halui.program.is-running" might be more like what he is after?
The following user(s) said Thank You: timo
Please Log in or Create an account to join the conversation.
- chuckp47
- Offline
- New Member
-
Less
More
- Posts: 12
- Thank you received: 1
11 Apr 2025 16:06 #326076
by chuckp47
Replied by chuckp47 on topic Activity Light
Thanks, that's exactly what I'm looking for. We'll be experimenting with it.
Please Log in or Create an account to join the conversation.
Time to create page: 0.128 seconds