- LinuxCNC
- General LinuxCNC Questions
- Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
- dlc mnl
- Offline
- New Member
-
Less
More
- Posts: 11
- Thank you received: 1
03 Apr 2025 04:05 #325576
by dlc mnl
Recruitment of a consultant for Linux CNC using a Mesa 7i97t board was created by dlc mnl
Hello, I would like to see if anyone can help me with the Linux CNC configuration of a 7i97t Mesa board and a 7i75 board with Chinese T3D servo drivers. I would like to recruit an advisor who could help me and teach me with the configuration. Payment method to be agreed upon.
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19985
- Thank you received: 6783
03 Apr 2025 04:18 #325579
by tommylight
Replied by tommylight on topic Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
forum.linuxcnc.org/10-advanced-configura...to-example-mesa-7i77
The same procedure and tuning is valid for 7i97T.
Especially mind the wiring of e-stop and drive enable, those can not be skipped.
-
First you have to get the drives running correctly, with no Mesa and no LinuxCNC. This i can not help with, the rest is quite easy, just follow the above and post here whenever you bump into something strange.
The same procedure and tuning is valid for 7i97T.
Especially mind the wiring of e-stop and drive enable, those can not be skipped.
-
First you have to get the drives running correctly, with no Mesa and no LinuxCNC. This i can not help with, the rest is quite easy, just follow the above and post here whenever you bump into something strange.
Please Log in or Create an account to join the conversation.
- Todd Zuercher
-
- Away
- Platinum Member
-
Less
More
- Posts: 4984
- Thank you received: 1453
03 Apr 2025 11:27 #325607
by Todd Zuercher
Replied by Todd Zuercher on topic Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
If you are looking for on site assistance, it might help to start with saying where you are located. There are Linuxcnc users all over the world. (And a few might even have spare time to pop in and give you a hand.)
The following user(s) said Thank You: tommylight
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19985
- Thank you received: 6783
04 Apr 2025 12:38 #325684
by tommylight
Replied by tommylight on topic Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
Did you find anyone?
Or did you try yourself?
Or did you try yourself?
Please Log in or Create an account to join the conversation.
- LinuxCNC
- General LinuxCNC Questions
- Recruitment of a consultant for Linux CNC using a Mesa 7i97t board
Time to create page: 0.104 seconds