1. LinuxCNC
  3. General LinuxCNC Questions
  5. Probe Error causes Jog lockout

Probe Error causes Jog lockout

More
23 Dec 2025 03:24 #340410 by Thllll
Probe Error causes Jog lockout was created by Thllll
2.9.4, Probe Basic

Probing failure either a g38.2 or g38.3 locks out the jog, 
Estop cycle , machine power cycle , probe on or off, homing, locks out jogging in all directions. Any way to reset this without restarting Linuxcnc?

Please Log in or Create an account to join the conversation.

  1. LinuxCNC
  3. General LinuxCNC Questions
  5. Probe Error causes Jog lockout
Time to create page: 0.041 seconds
Powered by Kunena Forum