1. LinuxCNC
  3. General LinuxCNC Questions
  5. Tuning lichuan servos

Tuning lichuan servos

  • Philip Lydin
  • Away
  • Senior Member
  • Senior Member
More
10 May 2026 19:49 #346316 by Philip Lydin
Tuning lichuan servos was created by Philip Lydin
I’m trying to tune my eethercat lichuan a5 servos but I’m getting around 0.02mm ferror instantly regardless the speed which then quickly drops to a couple microns steady. Can you recommend a way to fix it or is it ok as is?

Please Log in or Create an account to join the conversation.

  1. LinuxCNC
  3. General LinuxCNC Questions
  5. Tuning lichuan servos
Time to create page: 0.078 seconds
Powered by Kunena Forum