EMC2 loosing position
28 Apr 2011 00:38 #9434
by jslindsay
Replied by jslindsay on topic Re:EMC2 loosing position
is there a way to get an older version of the software? I'm running this on Ubuntu 8.04 with the latest EMC2, and on 10.? and the latest EMC2. I just remember it working, and I think I had an older version of EMC2 at the time.
Please Log in or Create an account to join the conversation.
28 Apr 2011 02:02 #9437
by jslindsay
Replied by jslindsay on topic Re:EMC2 loosing position
While reviewing online documentation I came across an article about my driver board. A modification was made to the sync of the driver chip to keep it sync with EMC2. I have made the hardware modification and running a test presently.
I hope this fixes it.
John
I hope this fixes it.
John
Please Log in or Create an account to join the conversation.
28 Apr 2011 11:53 #9455
by BigJohnT
Replied by BigJohnT on topic Re:EMC2 loosing position
I hope that fixes it... stuff like that can be very hard to find.
John
John
Please Log in or Create an account to join the conversation.
28 Apr 2011 12:23 #9457
by jslindsay
Replied by jslindsay on topic Re:EMC2 loosing position
Thanks to everyone who have offered assistance. It appears that the hardware fix took care of the problem. After 9 hours of running, the zero point is still in the same position as it was in the beginning.
This has been a very long 3 weeks of not making any parts!!!!
John
This has been a very long 3 weeks of not making any parts!!!!
John
Please Log in or Create an account to join the conversation.
28 Apr 2011 22:23 #9476
by Rick G
Replied by Rick G on topic Re:EMC2 loosing position
Glad to hear you are up and running, the only way to look at something like this is that time was lost but knowledge was gained.
Good luck,
Rick G
Good luck,
Rick G
Please Log in or Create an account to join the conversation.
29 Apr 2011 01:49 #9491
by jslindsay
Replied by jslindsay on topic Re:EMC2 loosing position
I've paid less for college credits. OH well, some engineer I turned out to be.
thanks everyone.
thanks everyone.
Please Log in or Create an account to join the conversation.
Time to create page: 0.162 seconds