Out of bounds
20 May 2011 18:40 #9952
by beermkr
Out of bounds was created by beermkr
I have an issue lately with a measurement showing out of bounds when the limits are outside of the measurement. In other words my z axis can go from -0.5 to 3.2 and the part is at 0.05 but it shows a limit violation.
Any help?
Any help?
Please Log in or Create an account to join the conversation.
20 May 2011 20:16 #9954
by BigJohnT
Replied by BigJohnT on topic Re:Out of bounds
You could have an offset that makes you go out of bounds or you might want to tweak your soft limits. I had to make my Z limits a bit bigger on my lathe to quit getting that error when trying to run some programs.
John
John
Please Log in or Create an account to join the conversation.
20 May 2011 22:41 #9957
by beermkr
Replied by beermkr on topic Re:Out of bounds
That is what I ended up doing. It was strange because my z limit was -.25 inches and it showed a red box for 0.05. I changed it to -.5 and it works fine. Weird!
R/
R/
Please Log in or Create an account to join the conversation.
20 May 2011 22:52 #9958
by BigJohnT
Replied by BigJohnT on topic Re:Out of bounds
Cool, can I take it by your moniker that you make beer?
My website is gnipsel.com some beer making and wine making there too.
John
My website is gnipsel.com some beer making and wine making there too.
John
Please Log in or Create an account to join the conversation.
20 May 2011 23:59 #9960
by beermkr
Replied by beermkr on topic Re:Out of bounds
Nice site. I used to homebrew and owned a homebrew shop in Norfolk, VA called HomeBrewUSA. We sold it a few years ago and no I don't do much homebrewing. Instead this is what I get to do: www.therivercompanybrewery.com
R/
R/
Please Log in or Create an account to join the conversation.
21 May 2011 12:05 #9966
by BigJohnT
Replied by BigJohnT on topic Re:Out of bounds
Cool place... I've been to Radford a number times when I worked for the nail factory. Nice area to visit.
John
John
Please Log in or Create an account to join the conversation.
Time to create page: 0.197 seconds