Forum Menu

pncconfig error

More
5 years 11 months ago #188446 by kevin19
pncconfig error was created by kevin19
Hello, I am using a 4 stepper motor machine and the mesa 6i25 card with a 7i75 breakout card and the gecko drivers used are the G214V. I wanted to do the pncconf wizard to configure my mesa card and I chose the 7i76*2 firmware as I have to connect the step, dir,fullstep, enable, error of each driver... but I get the following error. Can someone help me?


Please Log in or Create an account to join the conversation.

More
5 years 11 months ago #188447 by PCW
Replied by PCW on topic pncconfig error
Can you post your hal/ini files?

Please Log in or Create an account to join the conversation.

More
5 years 11 months ago #188449 by kevin19
Replied by kevin19 on topic pncconfig error
hello, here it is.:)

Please Log in or Create an account to join the conversation.

More
5 years 11 months ago #188451 by PCW
Replied by PCW on topic pncconfig error
What firmware is loaded on the 5I25?

what does

sudo mesaflash --device 5i25 --readhmid

report?

Please Log in or Create an account to join the conversation.

More
5 years 11 months ago #188452 by tommylight
Replied by tommylight on topic pncconfig error
How is the 7i76 powered ?

Please Log in or Create an account to join the conversation.

More
5 years 11 months ago #188454 by kevin19
Replied by kevin19 on topic pncconfig error
I get mesaflash: command not found

maybe is it because I am using ubuntu? I do bash LaunchCNC.sh to launch either pncconf or stepconf.

Please Log in or Create an account to join the conversation.

Moderators: cmorley
Time to create page: 0.416 seconds
Powered by Kunena Forum