Cannot get stepper motors to move

Fixed the 'never-default" , but still no connection to Linuxcnc....

will Debian 11 5.10.0-11-rt-amd64 running Linuxcnc 2.9 actually work, and by "work" I mean operate a machine?

What does the command

ip a

report?

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: enp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
link/ether c0:25:a5:91:90:85 brd ff:ff:ff:ff:ff:ff
inet 10.10.10.10/24 brd 10.10.10.255 scope global enp1s0
valid_lft forever preferred_lft forever
inet 10.10.10.100/24 brd 10.10.10.255 scope global secondary enp1s0
valid_lft forever preferred_lft forever
3: wlx1cbfce7a8336: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 1c:bf:ce:7a:83:36 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.12/24 brd 192.168.1.255 scope global dynamic noprefixroute wlx1cbfce7a8336
valid_lft 54856sec preferred_lft 54856sec
inet6 fe80::3f28:fbcd:2ff1:63e4/64 scope link noprefixroute
valid_lft forever preferred_lft forever

enp1s0 is not setup correctly (it has two IP addresses: 10.10.10.10 and an aliased address: 10.10.10.100)

The 10.10.10.10 address needs to be removed

Do you know where i need remove this?
Network manager does not show a .10 address