Cannot get stepper motors to move

Found a .10 under interfaces and deleted it.
now ip a shows:
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: enp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
link/ether c0:25:a5:91:90:85 brd ff:ff:ff:ff:ff:ff
inet 10.10.10.100/24 brd 10.10.10.255 scope global enp1s0
valid_lft forever preferred_lft forever
inet 169.254.156.42/16 brd 169.254.255.255 scope global noprefixroute enp1s0
valid_lft forever preferred_lft forever
3: wlx1cbfce7a8336: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 1c:bf:ce:7a:83:36 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.12/24 brd 192.168.1.255 scope global dynamic noprefixroute wlx1cbfce7a8336
valid_lft 86224sec preferred_lft 86224sec
inet6 fe80::3f28:fbcd:2ff1:63e4/64 scope link noprefixroute
valid_lft forever preferred_lft forever

ok, now linuxcnc will start, but my control buttons are greyed out. toggled estop, no change

Have you enabled EStop in the configuration? this might
cause this behaviour if the external signals are not correct

I just double checked, e-stop is not enabled

Can you post your hal and ini files?

Yes, they are at the beginning of this thread, I have not changed them yet.