No channel 4 stepgen direction on Mesa 7i92T

Note that those device names would be "7i92t" for a 7I92t[x]

Edited my previous post to reflect card name denominator.

Thanks for the reply.
I can ping 10.10.10.10 and it is successful.
I put in mesaflash --device 7i92 --addr 10.10.10.10 --readhmid and I get no 7i92 board found.
I tried mesaflash --device 7i92t --addr 10.10.10.10 --readhmid and I get No 7i92t board found.
I put in mesaflash --device 7i92th --addr 10.10.10.10 --readhmid and I get no 7i92th board found.
Everything worked fine before I updated Mesaflash and my cnc router works OK (except for A axis)
I install the latest version of mesaflash because 7i92t manual said I needed version 3.4.5 or later.
Hope someone can help.
Thanks Jan

What does the command:

ip a

report?

Also. what does

mesaflash --version

report

ip a gives me this.
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp2s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
link/ether c4:34:6b:54:a2:2a brd ff:ff:ff:ff:ff:ff
inet 10.10.10.11/24 brd 10.10.10.255 scope global enp2s0
valid_lft forever preferred_lft forever
inet6 fe80::c634:6bff:fe54:a22a/64 scope link
valid_lft forever preferred_lft forever
jan@cnc:/media/jan/5889-83DB$

mesaflash version 3.4.7

thanks
jan

Very strange, what does:

mesaflash --device ethernet --addr 10.10.10.10

report?