help: axes do not have an exact angle of 90°
- kaufparkangucker
- Offline
- New Member
-
Less
More
- Posts: 6
- Thank you received: 0
19 Sep 2013 18:10 #39019
by kaufparkangucker
help: axes do not have an exact angle of 90° was created by kaufparkangucker
hello,
sorry, my english is not so good.
I have a 3 axes router where the angle between x and y axis is not exact 90°.
The angle is 90.7°.![:ohmy: :ohmy:](/media/kunena/emoticons/shocked.png)
Is there a possibility to programm this value in my LinuxCNC programm?
Thanks for any idea and help.
With warm regards
Rocco
sorry, my english is not so good.
I have a 3 axes router where the angle between x and y axis is not exact 90°.
The angle is 90.7°.
![:ohmy: :ohmy:](/media/kunena/emoticons/shocked.png)
Is there a possibility to programm this value in my LinuxCNC programm?
Thanks for any idea and help.
With warm regards
Rocco
Please Log in or Create an account to join the conversation.
19 Sep 2013 19:49 #39021
by ArcEye
Replied by ArcEye on topic help: axes do not have an exact angle of 90°
The following user(s) said Thank You: kaufparkangucker
Please Log in or Create an account to join the conversation.
19 Sep 2013 19:50 #39022
by andypugh
Have a look at: wiki.linuxcnc.org/cgi-bin/wiki.pl?Contri...y_XY_skew_correction
Replied by andypugh on topic help: axes do not have an exact angle of 90°
I have a 3 axes router where the angle between x and y axis is not exact 90°.
The angle is 90.7°.
Have a look at: wiki.linuxcnc.org/cgi-bin/wiki.pl?Contri...y_XY_skew_correction
The following user(s) said Thank You: kaufparkangucker
Please Log in or Create an account to join the conversation.
- kaufparkangucker
- Offline
- New Member
-
Less
More
- Posts: 6
- Thank you received: 0
20 Sep 2013 01:48 #39036
by kaufparkangucker
Replied by kaufparkangucker on topic help: axes do not have an exact angle of 90°
Thanks, I'll try it
Please Log in or Create an account to join the conversation.
Time to create page: 0.066 seconds