Needing help to get started!
- agrimani
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
03 May 2026 19:00 #346141
by agrimani
Needing help to get started! was created by agrimani
Someone loaned me a Probotix-based CNC Router. I need to make up some very simple wood frames, but I cant seem to the the controller to recognize the router table. I realize that I know very very little about LinuxCNC, and would rather contract and pay someone to help me. This could be local, in Novato, CA near San Francisco, or by remote desktop (Teamviewer, Anydesk, etc.). Could someone make some time to look at the setup and get me started?
Thanks!!
Anthony (415) 883-1476
Thanks!!
Anthony (415) 883-1476
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 21579
- Thank you received: 7367
16 May 2026 14:56 #346439
by tommylight
Replied by tommylight on topic Needing help to get started!
Did you find anyone to help?
If not, post some pictures here, we are quite good at figuring out things from pictures and videos.
Also some pictures of the insides of control box would help a lot.
If not, post some pictures here, we are quite good at figuring out things from pictures and videos.
Also some pictures of the insides of control box would help a lot.
Please Log in or Create an account to join the conversation.
Time to create page: 0.051 seconds